Industrial Grouts and Floor Hardeners

Product Details:

Description / Advantages:

Cementatious Non shrink, Free Flow Ultra High Strength Grouts ,Free flow grouts for even small gaps Given strength of M70 grade Controlled expansion to ensure 100% contact area under base plates after setting. Needs only addition of specified quantity of water and mixing mecha- nically it is ready to use

Application:

• Can be used for Machine base plate grouting DG sets., Pumps, turbo generators, crane rails turbines steel rolling machine bands etc., can with stand static & dynamic loads

How to use:

• Mix 4.25 litres of water for pack of 25 kg grouts at a water ratio of 0.17.

Product Details:

• Shrinking Compensated polymer modified free flow repair concrete

Product Details:

Description / Advantages:

It is a Metallic & Non metallic concrete floor hardener for very high abrasion resistance flooring. It provides a very high abrasion resistance surface to concrete floors by dry shake on system and to ensure hard wearing surface. Bonds immensely to the base concrete Surface.

Application:

• Suitable for all industrial areas subjected to heaviest traffic, shops floors, heavy engineering industries, ramps, trucking lanes etc.

How to use:

• To be used as a dry shake by spreading on freshly laid concrete surfaces.

Product Details:

Description / Advantages:

Cementatious Non shrinks, free Flow grout Strength of M 50 grades can be achieved which cannot be matched by sand/cement grouts. Ready to use addition of specified quantity of water and mixing mechanically Controlled expansion ensures surface contact area of 100% below base plates of machinery.

Application:

• Can be used in construction grouting deep anchors bolt pockets machine turbines DG sets trans- formers etc.

How to use:

• Mix 4.5 litres of water for pack of 25kg grout at a water powder ratio of 0.18

Product Details:

Description / Advantages:

Cementatious Non shrink, Free Flow Ultra High Strength Grouts , Free flow grouts for even small gaps Given strength of M90 grade. Excellent non shrink property Excellent high initial and final strength ,it has special additives and grades .which are compactable with concrete substrates.

Application:

• Heavy duty foundations. Base plates and bolt pockets of turbo generators Columns & precast Concrete structures, Diesel generator sets cement/ textile/paper mill machinery, steel rolling mill beds. Crane and transport rails Concrete anchors Cavities, gaps and recesses can withstand static & dynamic loads

How to use:

• Mix 4.25 litres of water for pack of 25 kg grouts at a water ratio of 0.16

Product Details:

Description / Advantages:

It is a two component low Viscosity Epoxy Resin Injection Grout. It has very high flow ability and excellent bond strength.

Application:

• It can be applied as crack injection and for filling cold joints. It can also be used for filing base plates and bolt pockets with gap less than 10 mm.

How to use:

• Mix base & reactor thoroughly & see that the mixed material is injected well.

Product Details:

Description / Advantages:

Three component Low exotherm epoxy Resin Grout. Can be installed rapidly and has very high strength can be developed It is also chemical resistant, non shrink agent and develops good bonding strength.

Application:

• Can be used as a free flow grout where mechanical properties and chemical resistance of high order are required.

• At the time of mixing of the base, reactor filler has to be done by a mechanical mixer.Material has to be used within the pot life.